Product Installation Instructions for Water Pump Compatible with Models YM169, YM180, YM186

Tools Required:

1. Socket Wrench Set
2. Screwdriver Set (both Phillips and flathead)
3. Pliers
4. Fresh Water for testing
5. Towels or rags for cleaning up spills
6. Safety Gloves

Installation Steps:

1. Preparation:

   • Ensure the machine is turned off and cool before beginning installation.
   • Disconnect the power supply to ensure safety.

2. Remove the Old Water Pump:

   • Use a socket wrench to remove the bolts securing the old water pump.
   • Carefully detach any hoses connected to the old pump, using pliers if necessary.
   • Clean the area where the old pump was installed to remove any dirt or debris.

3. Install the New Water Pump:

   • Position the new water pump in place, aligning it with the bolt holes.
   • Secure the pump with the bolts using a socket wrench.
   • Reattach any hoses, ensuring that they are firmly connected to prevent leaks.

4. Testing:

   • Reconnect the power supply and turn on the machine.
   • Allow the machine to run for a few minutes to check for leaks and ensure proper operation.
   • If necessary, use fresh water to test the flow from the new pump.

5. Final Touches:

   • Wipe any excess water or spills using towels or rags.
   • Double-check all connections and ensure everything is secure.

Safety Note:
Always wear safety gloves during installation to protect your hands from sharp edges or other hazards.

With these simple tools and steps, you can easily replace your water pump and ensure optimal performance for your equipment.