Product Installation Instructions for Carburetor HS76 Replacement Compatible With WT-264

Tools Required:

1. Screwdriver Set (Flathead and Phillips)
2. Wrench Set (for nut and bolt removal)
3. Pliers
   4.Clean Cloth or Rag
4. Fuel Line Pliers (optional)
5. Safety Goggles
6. Work Gloves

Installation Steps:

1. Preparation:

   • Ensure the trimmer is turned off and completely cool. Disconnect the spark plug wire for safety.
   • Gather all required tools and materials. Working in a well-ventilated area is recommended.

2. Remove the Old Carburetor:

   • Locate the carburetor on your trimmer.
   • Using the appropriate screwdriver, remove any screws or bolts securing the carburetor in place.
   • Carefully detach the fuel lines connected to the old carburetor. It may be helpful to use fuel line pliers to avoid damaging the lines.

3. Clean the Area:

   • Use a clean cloth to wipe down the area around the carburetor mounting point. This ensures a clean surface for the new carburetor.

4. Install the New Carburetor:

   • Align the new HS76 carburetor with the mounting points.
   • Secure the carburetor using the screws or bolts removed earlier. Ensure it is tightly fastened but avoid over-tightening.

5. Reconnect Fuel Lines:

   • Attach the fuel lines to the new carburetor. Ensure the connections are secure to prevent leaks.

6. Reconnect the Spark Plug:

   • Once everything is installed and secured, reconnect the spark plug wire.

7. Testing:

   • Before starting the trimmer, double-check all connections and ensure there are no leaks.
   • Start the trimmer and allow it to run for a few minutes to check for proper operation. Adjust as needed.

8. Cleanup:

   • Dispose of any old parts and materials properly.

Note:
By following these steps, you can efficiently replace your carburetor and enhance your trimmer's performance. If you encounter any issues during installation, please consult the user manual or seek professional assistance.