Installation Instructions for Metal Drive Shaft Compatible with 1/12 Scale RC Cars

Included:

• 2 Metal Drive Shafts
  -Installation Guide

Tools Required:

• Phillips Screwdriver
• Flathead Screwdriver
• Hex Wrench Set (if applicable)
• Pliers (optional)
  -Clean Cloth

Installation Steps:

1. Preparation:
   Before starting the installation, ensure your RC car is turned off and remove the battery for safety.

2. Tools Gathering:
   Collect all the tools listed above. Having everything ready will make the installation process smoother.

3. Remove Old Drive Shaft:

   • Use the Phillips screwdriver to remove the screws securing the old drive shaft to the chassis and the wheel assembly.
   • Carefully detach the old drive shaft from the RC car, ensuring no other components are damaged in the process.

4. Install New Metal Drive Shaft:
   -Align the new metal drive shaft with the connection points on the chassis and wheel assembly.

   • Insert and tighten the screws using the Phillips screwdriver, ensuring a snug fit.
   • If your model requires specific hex screws, use the hex wrench set to secure them appropriately.

5. Check Connections:
   After installation, manually spin the wheels to ensure the drive shaft rotates smoothly without any obstruction or unusual noise.

6. Final Checks:

   • Wipe down any excess grease or debris from the installation area using a clean cloth.
   • Ensure all screws are tight and the drive shaft is securely attached.

7. Reinstall Battery:
   Once you are satisfied with the installation, reinstall the battery and turn on the RC car.

8. Test Drive:
   Finally, take your RC car for a test drive on varied terrain to evaluate the performance and handling improvements from the new metal drive shafts.

Note: If you encounter any issues during installation, please refer to your RC car’s user manual for additional guidance. Enjoy the enhanced performance of your RC vehicle!