Product Installation Instructions for 10 Piece Metal Upgrade Bearings 4x7x2mm

Tools Needed:

1. Screwdrivers:

   • A set of small screwdrivers, specifically Phillips and flathead types, to remove the screws on your RC car.

2. Pliers:

   • Needle-nose pliers may be useful for gripping and maneuvering small parts.

3. Tweezers:

   • For handling small bearings and ensuring precise placement.

4. Hobby Knife (optional):

   • To clean any debris or old lubricant from the bearing slots, if necessary.

5. Lubricant (optional):

   • A light bearing oil can be applied for added smoothness if desired.

Installation Steps:

1. Preparation:

   • Ensure your workspace is clean and organized. Gather all the tools mentioned above and the new metal upgrade bearings.

2. Remove the Old Bearings:

   • Use a screwdriver to remove any screws holding the components in place. Carefully take apart the sections where the bearings are located.
   • Gently pry out the old bearings using tweezers or pliers, being cautious not to damage other parts of the RC car.

3. Clean the Bearing Slots:

   • Inspect the slots for any debris or residue from the old bearings. Use a hobby knife or a soft cloth to clean them thoroughly.

4. Install New Bearings:

   • Take one of the new metal upgrade bearings and carefully insert it into the bearing slot. Ensure it sits flush and is aligned correctly.
   • Repeat for all remaining bearings, ensuring each one is seated properly.

5. Reassemble the RC Car:

   • Once all new bearings are installed, reassemble the components of your RC car by carefully putting them back together, using the appropriate screws to secure everything.

6. Final Check:

   • Give a final inspection to ensure all components are secured and nothing is loose. You may also apply a small amount of lubricant to the bearings if desired.

7. Test Your RC Car:

   • Power on the RC car and test its movement. You should notice improved performance with reduced friction and enhanced maneuverability.

Enjoy your upgraded RC experience with your new metal bearings!