Product Installation Instructions for Air Filter Replacement Compatible with EH41 Engine Parts Model 267-32601-20

Tools Required:

1. Screwdriver (Philips or Flathead as needed)
2. Clean, dry cloth
3. Safety gloves (optional)
4. Vacuum cleaner (optional, for cleaning debris)

Installation Steps:

1. Safety First:
   Before starting the installation, ensure the engine is turned off and has cooled down. If necessary, wear safety gloves to protect your hands.

2. Locate the Air Filter Housing:
   Identify the air filter housing in your EH41 engine. This is typically located near the engine block, and it may be secured with screws or clips.

3. Remove the Housing Cover:
   Use the screwdriver to loosen and remove the screws or clips holding the air filter housing cover in place. Set the cover aside carefully.

4. Take Out the Old Air Filter:
   Gently pull out the old air filter from the housing. If there is any debris or dirt in the housing, use the vacuum cleaner or cloth to clean the area before installing the new filter.

5. Install the New Air Filter:
   Take the new air filter compatible with model 267-32601-20 and place it into the housing. Ensure that it is seated properly and fits snugly.

6. Reattach the Housing Cover:
   Once the new air filter is in place, put the housing cover back on and secure it using the screws or clips you removed earlier.

7. Final Check:
   Inspect the installation to make sure everything is tight and secure. Ensure there are no gaps or loose parts.

8. Start the Engine:
   Turn on the engine and check for any unusual noises or issues. Your engine should now run smoothly with the new air filter installed.

Maintenance Tip:
Regularly check and replace your air filter to maintain engine performance and improve fuel efficiency.