Installation Instructions for the Oil Filter Drain Plug Set (Compatible with 49cc, 50cc, 125cc, and 150cc Scooter Moped ATV Engines)

Tools Required:

1. Socket Wrench Set
2. Screwdriver (Phillips and Flathead)
3. Pliers
4. Oil Catch Pan
5. Clean Rags or Paper Towels

Step-by-Step Installation Guide:

1. Prepare the Work Area:

   • Place your scooter, moped, or ATV on a flat surface.
   • Ensure the engine is cool to avoid burns.

2. Gather Your Tools:

   • Collect all the tools listed above to ensure a smooth installation process.

3. Drain the Existing Oil:

   • Locate the oil drain plug on your engine.
   • Use the appropriate socket wrench to remove the plug and drain the old oil into the oil catch pan.
   • Allow the oil to fully drain before proceeding.

4. Remove the Old Oil Filter:

   • Locate the old oil filter.
   • Use pliers or a filter wrench to carefully unscrew and remove the old filter.
   • Be cautious as residual oil may still be in the filter.

5. Install the New Oil Filter:

   • Take your new oil filter from the Oil Filter Drain Plug Set.
   • Before installation, apply a small amount of new oil to the rubber gasket of the new filter. This helps create a better seal.
   • Screw the new filter onto the engine by hand until it is snug, and then tighten it gently with a wrench.

6. Reinstall the Drain Plug:

   • Ensure the old washer is replaced if necessary.
   • Reinstall the oil drain plug using your socket wrench. Tighten securely, but do not over-tighten to avoid stripping the threads.

7. Add New Oil:

   • Refer to your vehicle's manual for the correct type and amount of oil required.
   • Open the oil fill cap and pour new oil into the engine.

8. Check for Leaks:

   • Start the engine and let it run for a few minutes.
   • Check around the new filter and drain plug for any signs of leaking oil.

9. Dispose of Old Oil Properly:

   • Dispose of the old oil and filter in accordance with your local regulations.

10. Final Checks:

    • Ensure all tools are collected from the work area.
    • Close the oil fill cap securely.

Your installation is now complete! Enjoy the enhanced performance of your scooter, moped, or ATV with the new Oil Filter Drain Plug Set.