Installation Instructions for Flexible Replacement Ribbon Wire for Camera Repair Compatible with PM 4, PM 4 Pro, and Phantom 4 Pro 2.0

Tools Required:

1. Screwdriver Set: A small Phillips and flat-head screwdriver are essential for removing screws from the camera casing.

2. Tweezers: Helpful for handling small components and connecting the ribbon wire securely.

3. Plastic Pry Tool: A non-metallic tool can assist in opening the camera casing without causing damage.

4. Anti-Static Wrist Strap: To prevent static electricity from damaging electronic components during the installation process.

5. Clean, Flat Workspace: Ensure you have a clean, well-lit, and flat surface to work on, free of any clutter.

Installation Steps:

1. Power Off the Device: Before starting, make sure the camera and drone are powered off completely to avoid any electrical shock or short circuits.

2. Remove the Camera Casing: Use the screwdriver to carefully remove the screws securing the camera casing. Place the screws in a small container so they do not get lost.

3. Detach the Old Ribbon Wire: Using tweezers, carefully disconnect the old ribbon wire. Take note of how it is connected for reference during installation.

4. Install the New Ribbon Wire: Align the new flexible replacement ribbon wire correctly and firmly connect it to the camera's circuit board. Ensure it is seated properly.

5. Reassemble the Camera Casing: Once the new wire is in place, carefully close the camera casing and secure it with the screws you removed earlier.

6. Power On the Device: After reassembling, power on the drone and check to ensure the camera is functioning correctly.

Additional Tips:

• Handle all components with care to avoid any damage.
• If unsure about the connection, refer to the original manual or online tutorials for guidance.

By following these instructions, you can effectively replace the ribbon wire and ensure your camera operates smoothly post-repair.