Product Installation Instructions for Carburetor Gasket Kit for L4621 Lawn Mower Model 967644501

Tools Required:

• Screwdriver (Flathead and Phillips)
  -Wrench set
  -Pliers
  -Clean cloth or rag
• Safety gloves
• Safety goggles

Installation Steps:

1. Preparation:

   • Ensure the lawn mower is turned off and disconnected from any power source.
   • Wear safety gloves and goggles for protection.

2. Remove the Old Gasket:

   • Use the screwdriver to remove any screws securing the carburetor cover.
   • Carefully detach the carburetor from the engine.
   • Remove the old gasket, ensuring no remnants are left on the carburetor or engine surface.

3. Clean the Surfaces:

   • Use a clean cloth to wipe down the carburetor and engine surfaces, removing any dirt or debris.

4. Install the New Gasket:

   • Place the new gasket from the Carburetor Gasket Kit onto the carburetor, ensuring it aligns perfectly with the holes.

5. Reattach the Carburetor:

   • Position the carburetor back onto the engine.
   • Secure it in place using the screws removed earlier. Tighten them with the appropriate screwdriver.

6. Final Checks:

   • Ensure all connections are tight and there are no loose parts.
   • Reconnect any power source if applicable.

7. Test the Lawn Mower:

   • Start the lawn mower to ensure it runs smoothly without any air leaks.

By following these steps, you can successfully install the Carburetor Gasket Kit and enhance the performance of your L4621 lawn mower.