Installation Instructions for Ignition Coil with Cap 6E0-85570

Compatibility:
This ignition coil is compatible with various 2T 4HP and 5HP outboard motors, ensuring broad compatibility to meet multiple needs.

Tools Required:
Before you begin the installation, gather the following tools:

1. Screwdriver Set (Flathead and Phillips)
2. Socket Wrench Set
3. Pliers
4. Wire Strippers/Cutters
5. Torque Wrench
6. Electrical Tape
7. Safety Glasses
8. Gloves

Installation Steps:

1. Preparation:
   Ensure the outboard motor is turned off and cooled down. Disconnect the battery to prevent any electrical mishaps.

2. Remove Old Ignition Coil:

   • Locate the existing ignition coil on the motor.
   • Use the screwdriver or socket wrench to remove the screws or bolts securing the old ignition coil.
   • Carefully disconnect the wiring harness and remove the old ignition coil.

3. Install the New Ignition Coil:

   • Take the new ignition coil (6E0-85570) and connect the wiring harness to it.
   • Position the ignition coil in place and secure it using the screws or bolts. Ensure it is tightened properly without over-torquing.

4. Reconnect Battery and Wiring:

   • Reconnect the battery terminals.
   • Check all connections to ensure they are secure and properly insulated. Use electrical tape where necessary to prevent any exposed wiring.

5. Test the Installation:

   • Start the outboard motor to ensure the ignition coil is functioning properly.
   • Observe the motor's performance; it should start easily and run smoothly.

6. Final Check:

   • After installation, check for any loose connections or abnormalities.
   • Confirm that tools are properly stored away and the work area is clean.

Important Note:
If you encounter any issues during installation, refer to the motor’s user manual or consult a professional mechanic for assistance.

By following these instructions, you can effectively replace your ignition coil and enhance your outboard motor’s performance. Enjoy your improved boating experience!