Installation Instructions for Replacement Lamp Compatible with Projector Models CP-X200, CP-X205, CP-X300, CP-X300WF, CP-X305, CP-X308, CP-X400, CP-X417, ED-X30 Model DT00841 RLC- 031 456-8755G 78-6966-9917-2

Tools Needed:

1. Screwdriver (Phillips or Flathead, depending on your projector model)
2. Soft cloth or lint-free towel
3. Safety gloves (optional, for handling the lamp)

Installation Steps:

1. Preparation:

   • Ensure the projector is turned off and disconnected from the power source.
   • Allow the projector to cool down for at least 30 minutes if it has been in use.

2. Gather Tools:

   • Collect the screwdriver and a soft cloth to handle the lamp.

3. Remove the Old Lamp:

   • Locate the lamp access door on your projector.
   • Use the screwdriver to remove the screws securing the access door, then carefully remove the door.
   • Gently unclip the old lamp from its housing, taking care not to touch the glass part of the lamp.

4. Install the Replacement Lamp:

   • Using the soft cloth, handle the new replacement lamp by its casing to avoid direct contact with the glass.
   • Align the new lamp with the projector’s housing and gently push it into place until it is fully seated.
   • Reattach any clips or fasteners that hold the lamp in place.

5. Reattach the Access Door:

   • Position the access door back onto the projector and secure it with the screws.
   • Ensure that the door is properly sealed to avoid any dust or debris entering the projector.

6. Final Check:

   • Reconnect the projector to the power source.
   • Turn on the projector to ensure the new lamp is functioning correctly.
   • If necessary, adjust settings for optimal image quality.

By following these simple steps, you can easily and safely replace the projector lamp with minimal tools required. Enjoy a brighter, clearer projection experience!