Product Installation Instructions for 4PCS 8x12x3.5mm Ball Bearings

Tools Required:

1. Screwdriver Set - Make sure you have both Phillips and flathead screwdrivers to accommodate different screw types.
2. Pliers - Useful for gripping parts and removing any stuck components.
3. Tweezers - To handle small parts, especially during installation.
4. Hex Wrench Set - If your RC model uses hex screws, ensure you have the correct sizes.
5. Hobby Knife - For cutting any ties or securing materials that may be holding your parts together.
6. Lubricant - Optional, but recommended for extended longevity and smoother operation of the bearings.

Installation Steps:

1. Preparation:

   • Ensure your workspace is clean and well-lit.
   • Gather all necessary tools and the new ball bearings.

2. Disassembly:

   • Use the screwdriver or hex wrench to carefully remove any screws holding the wheel or component in place.
   • Gently detach the part associated with the old bearings.

3. Remove Old Bearings:

   • Use pliers or your fingers to pull out the old bearings. If they are stuck, use the hobby knife to gently pry them from their housing.

4. Install New Bearings:

   • Take the new 8x12x3.5mm ball bearings and carefully insert them into their designated slots. Ensure they are seated properly.

5. Reassemble:

   • Reattach the wheel or component by aligning it back into place.
   • Secure everything using your screwdriver or hex wrench, ensuring not to overtighten to avoid damaging the parts.

6. Test the Setup:

   • Once everything is reassembled, check for smooth rotation of the wheels and any other moving parts.
   • Ensure that there are no unusual sounds and that the vehicle operates as expected.

7. Final Check:

   • Double-check all screws and assemblies to ensure everything is tightened and secure before starting the RC model.

Congratulations on installing your new ball bearings! Enjoy the enhanced performance and durability of your RC model.