Installation Instructions for 10Pcs 7 Teeth Oil Pump Worm Drive Gear Set

Compatible Models:

• 2500 25CC 2500 2-Stroke
  -P360 Chainsaw

Tools Needed:

1. Screwdriver Set:

   • Flathead screwdriver
   • Philips screwdriver

2. Wrench Set:

   • Adjustable wrench or socket wrench for nut removal

3. Pliers:

   • Needle-nose pliers for gripping small parts

4. Hex Key Set:

   • For any hex screws that may need removal

5. Safety Gear:

   • Safety goggles
   • Work gloves

Installation Steps:

1. Preparation:

   • Ensure the chainsaw or engine is turned off and cool to the touch.
   • Disconnect the spark plug for safety.

2. Disassembly:

   • Use the screwdriver to remove any casing or covers that obstruct access to the oil pump.
   • Carefully remove the existing oil pump worm drive gear.

3. Install New Gear:

   • Take one of the new 7 Teeth oil pump worm drive gears from the kit.
   • Make sure it is properly aligned before fastening it into place.

4. Reassembly:

   • Replace any covers or casings that were removed earlier using the screwdriver and wrench.
   • Ensure everything is securely fastened.

5. Final Check:

   • Reconnect the spark plug.
   • Check for any loose parts and ensure the installation is secure.

6. Test Run:

   • Run the chainsaw briefly to ensure the new gear functions correctly and that there are no leaks from the oil pump.

Tips:

• Always refer to your chainsaw’s user manual for specific guidance on disassembly and assembly.
• Take your time with each step to ensure a proper fit and avoid damaging parts.

Thank you for choosing our 10Pcs 7 Teeth Oil Pump Worm Drive Gear Set. Enjoy enhanced performance and efficiency with your chainsaw!