Ignition Coil Module Installation Instructions for Loncin Zongsheng NP100, P57, NH130, and NH150 Lawn Mowers

Tools Required:

• Screwdriver (Phillips and Flathead)
  -Socket Wrench Set
  -Pliers
  -Torque Wrench
  -Cleaning Cloth
• Safety Goggles
• Gloves

Installation Steps:

1. Preparation:

   • Make sure your lawn mower is turned off and the spark plug is disconnected to avoid accidental starts.
   • Wear safety goggles and gloves for protection during the installation process.

2. Remove the Existing Ignition Coil:

   • Locate the ignition coil on your lawn mower. It is typically found near the engine.
   • Use the screwdriver to remove the screws or bolts securing the existing ignition coil. Keep these screws/bolts in a safe place for reinstallation.

3. Disconnect the Old Ignition Coil:

   • Carefully disconnect any wiring or connectors attached to the old ignition coil. Take note of how they are connected for easy reinstallation.

4. Install the New Ignition Coil:

   • Position the new ignition coil in place. Ensure it aligns perfectly with the mounting holes.
   • Reconnect the wiring and connectors as they were on the old ignition coil.

5. Secure the Ignition Coil:

   • Use the screwdriver or socket wrench to tighten the screws or bolts securing the ignition coil. Ensure they are snug but do not overtighten.

6. Reattach the Spark Plug:

   • Connect the spark plug back to its socket. This step is essential for the mower to start after installation.

7. Final Check:

   • Before starting the mower, double-check that all connections are secure and that all tools are removed from the area.

8. Start the Lawnmower:

   • Turn on the mower to test the new ignition coil. It should start easily and operate smoothly.

Conclusion:

Congratulations! You have successfully installed the ignition coil module for your Loncin Zongsheng NP100, P57, NH130, or NH150 lawn mower. Enjoy improved performance and efficiency.