Product Installation Instructions for EP Propellers

Models Compatible: EP5030, 6035, 7035, 8040, 8060, 9050, 1060, 1160

Tools Required:

1. Screwdriver - A small Phillips or flathead screwdriver, depending on the screws used for your model.
2. Pliers - To help grip and place the propeller securely.
3. Hex Key/Allen Wrench (if applicable) - For loosening or tightening any hex screws.
4. Scissors or Hobby Knife - For trimming any excess material or adjustments if necessary.

Installation Steps:

1. Preparation:

   • Ensure your RC airplane is powered down and the battery is disconnected for safety.
   • Lay out your tools for easy access.

2. Removal of Old Propeller:

   • Use the screwdriver or hex key to remove the screws holding the old propeller in place.
   • Carefully detach the old propeller from the motor shaft.

3. Installation of New Propeller:
   -Align the new EP propeller with the motor shaft.

   • Slide the propeller onto the motor shaft, ensuring it fits snugly.
   • Secure the propeller by reattaching the screws. Use the screwdriver or hex key to tighten them securely.

4. Final Checks:

   • Ensure the propeller is firmly attached and spins freely.
   • Double-check all screws for security.
   • Reconnect the battery and test the propeller by briefly powering the airplane.

Safety Precautions:

• Always ensure that the RC airplane is turned off and disconnected from power when working on it.
• Be aware of spinning propellers and maintain a safe distance.

By following these instructions, you'll have your new EP propellers installed in no time, enhancing your RC airplane's performance and flying experience. Enjoy your flight!