Product Installation Instructions for Ignition Coil Module

Compatible Models:
PS-460, PS-500, PS-5100S, PS-4600S, PS-5000

Tools Required:

1. Socket Wrench Set
   (to remove and install bolts and nuts)

2. Screwdriver Set
   (for any screws that may need to be removed)

3. Torque Wrench
   (to ensure bolts are tightened to the correct specifications)

4. Wire Cutters/Strippers
   (if any wiring adjustments are necessary)

5. Safety Gloves
   (to protect your hands during installation)

6. Safety Glasses
   (to protect your eyes from debris)

7. Cleaning Cloth
   (for cleaning components before installation)

Installation Steps:

1. Preparation:
   Ensure the device is off and disconnected from any power source. Wear safety gloves and glasses for protection.

2. Access the Ignition Coil Module:
   Remove any covers or components blocking access to the ignition coil module using the appropriate screwdriver or socket wrench.

3. Disconnect the Old Ignition Coil:
   Carefully disconnect the wiring harness from the old ignition coil. Note the position for reinstallation.

4. Remove the Old Ignition Coil:
   Use the socket wrench to remove the bolts securing the ignition coil. Separate the old coil from the mounting bracket.

5. Install the New Ignition Coil:
   Place the new ignition coil into position, securing it with the previously removed bolts. Make sure to tighten them to the recommended torque.

6. Reconnect the Wiring Harness:
   Connect the wiring harness to the new ignition coil, ensuring a secure fit.

7. Reassemble Components:
   Replace any covers or components removed to access the ignition coil module.

8. Final Check:
   Inspect all connections and ensure everything is secure.

9. Testing:
   Reconnect the device to the power source and start the engine to ensure proper operation.

Note:
Regular maintenance and timely replacement of ignition coils can significantly enhance the performance and reliability of your equipment.