Installation Instructions for Recoil Pull Starter for 4-Stroke Engine Compatible with GX35

Tools Required:

• Screwdriver (Philips or flathead depending on your screws)
• Wrench set (for any nuts and bolts)
• Pliers (for handling wires or tight spaces)
• Allen wrench set (if required for specific screws)
• Torque wrench (for proper tightening, if applicable)
• Safety gloves (to protect your hands during installation)
• Safety goggles (to protect your eyes from debris)

Installation Instructions:

1. Preparation:

   • Ensure the engine is turned off and is completely cool.
   • Disconnect the spark plug to prevent accidental starting.

2. Remove the Old Starter:

   • Locate the screws or bolts securing the old recoil starter.
   • Use the appropriate screwdriver or wrench to remove them.
   • Carefully detach the old starter from the engine.

3. Inspect the Area:

   • Clean any debris or dust around the starter mounting area to ensure a good seal.

4. Install the New Recoil Pull Starter:
   -Align the new recoil starter with the mounting holes on the engine.

   • Insert and hand-tighten the screws or bolts to hold the starter in place.

5. Secure the Starter:

   • Using the wrench or screwdriver, tighten the screws or bolts to the manufacturer's specifications to ensure a secure fit.
   • If applicable, use the torque wrench to confirm proper torque settings.

6. Reconnect the Spark Plug:

   • Once the recoil starter is securely installed, reconnect the spark plug.

7. Test the Starter:

   • Pull the starter cord gently to ensure it engages properly.
   • Check for any unusual noises or resistance.

8. Final Checks:

   • Make sure all tools are removed from the work area.
   • Start the engine to test the performance of the new recoil starter.

##Conclusion:
Your Recoil Pull Starter is now installed and ready for use! Enjoy enhanced performance and reliability with your 4-Stroke engine. Always follow the manufacturer's maintenance recommendations for optimal operation.