Installation Guide for Water Pump Impeller Kit

Required Tools:

1. Socket wrench or ratchet and socket: 10mm or 12mm socket (depending on the engine model)
2. Teflon tape or pipe dope: For thread sealing
3. Pliers: Needle-nose pliers for reaching small spaces
4. Torx screwdriver: For removing the impeller housing screw (if applicable)
5. Gasket sealant: For sealing the impeller housing (if applicable)
6. Waterproof grease: For lubricating the impeller shaft and bearings (if applicable)

Additional Tips:

1. Make sure to disconnect the battery before starting the installation process to avoid any accidental engine start-ups.
2. Remove any protective covers or trim pieces to access the water pump impeller area.
3. Take photos or notes of the original configuration to ensure proper reassembly.
4. Use a clean and dry workspace to prevent contamination and corrosion.
5. Follow all safety precautions when working with power tools and electrical systems.

Step-by-Step Instructions:

1. Remove the old impeller:

• Use a socket wrench or ratchet and socket to loosen the impeller housing screws.
• Gently pull the old impeller out of the housing.

2. Inspect and clean the impeller housing:

• Remove any debris, dirt, or old gasket material from the housing.
• Clean the housing with a soft brush or cloth to ensure a smooth surface for the new impeller.

3. Install the new impeller:

• Align the new impeller with the housing and gently push it into place.
• Make sure the impeller is securely seated and even with the housing.

4. Reattach the impeller housing:

• Use the socket wrench or ratchet and socket to tighten the housing screws in a star pattern.
• Apply Teflon tape or pipe dope to the threads for a secure seal.

5. Reconnect any electrical connections:

• Reconnect any electrical wires or connections that were disconnected during the installation process.

6. Test the water pump:

• Turn on the engine and check for leaks around the impeller area.
• Monitor the water flow and pressure to ensure proper function.

Maintenance Tips:

1. Regularly check the water pump impeller for wear and tear.
2. Clean or replace the impeller as needed to maintain optimal performance.
3. Use waterproof grease to lubricate the impeller shaft and bearings.

By following these steps and tips, you should be able to successfully install your new Water Pump Impeller Kit for Outboard Engines Compatible with Johnson F5 F6 F6B-9 Jabsco and Yamaha Models.