Air Mounting Flange Installation Instructions for Compatibility with S 066, 065, MS660, and MS650 Chainsaws

Tools Required:

1. Screwdriver Set

   • Phillips and flat-head screwdrivers for removing and reseating screws.

2. Wrench Set

   • Suitable for loosening and tightening any nuts or bolts if applicable.

3. Torque Wrench

   • To apply the correct torque specifications (if applicable).

4. Cleaning Brush

   • To clean the mounting area before installation.

5. Safety Gear

   • Gloves and goggles for personal protection during the installation process.

Installation Steps:

1. Preparation

   • Ensure your chainsaw is turned off and disconnected from any power source.
   • Wear safety gloves and goggles to protect yourself from debris.

2. Remove the Old Flange

   • Use the appropriate screwdriver to unscrew and detach the old air mounting flange from the chainsaw.
   • Make sure to keep all screws and components for reinstallation.

3. Clean the Area

   • Use a cleaning brush to thoroughly clean the mounting surface where the flange will be installed.

4. Install the New Air Mounting Flange

   • Position the new air mounting flange in place, aligning it with the screw holes.
   • Hand-tighten the screws initially to hold it in place.

5. Secure the Flange

   • Using the appropriate screwdriver or wrench, securely tighten all screws and bolts.
   • If necessary, use a torque wrench to ensure they are tightened to the specified torque settings.

6. Final Checks

   • Check to ensure that the flange is securely in place and there are no loose components.
   • Reconnect the chainsaw to its power source.

7. Test the Chainsaw

   • Start the chainsaw and run it briefly to test the new installation.
   • Monitor for any unusual vibrations or sounds, which may indicate improper installation.

Note:

Always refer to your chainsaw's manual for specific instructions and safety precautions related to your model. Enjoy enhanced performance and efficiency with your newly installed air mounting flange!