Installation Instructions for Motorcycle Side Covers and Tool Panels for 125cc Models

Tools Required:

1. Socket Wrench Set - For removing and tightening bolts.
2. Phillips Screwdriver - To unscrew any Phillips-head screws.
3. Flathead Screwdriver - For prying off covers if needed.
4. Pliers - To assist in gripping or twisting bolts and clips.
5. Torque Wrench - To ensure proper tightening of bolts (optional).
6. Cleaning Cloth - To wipe areas before installation.

Installation Steps:

1. Preparation:

   • Ensure the motorcycle is parked on a flat, stable surface.
   • Disconnect the motorcycle battery for added safety.

2. Remove Existing Side Covers:

   • Using the socket wrench, carefully remove the bolts securing the original side covers.
   • If necessary, use the Phillips and flathead screwdrivers to take off any additional screws or clips.
   • Gently pull off the existing side covers to avoid damaging any surrounding components.

3. Clean the Area:

   • Wipe down the area where the new side covers will be installed with a cleaning cloth to remove any dirt or debris.

4. Fit the New Side Covers:

   • Position the new side covers over the designated area.
   • Align the holes in the side covers with the mounting points on the motorcycle.

5. Secure the Side Covers:

   • Using the socket wrench and/or screwdrivers, carefully secure the new side covers by tightening the bolts and screws.
   • Ensure that everything is fastened snugly, but avoid over-tightening to prevent damage.

6. Reattach Battery:

   • Once both side covers are securely in place, reconnect the motorcycle battery.

7. Final Check:

   • Inspect the installation to ensure the new side covers are firmly attached.
   • Check that all tools are collected, and the work area is left clean.

Congratulations! You've successfully installed the motorcycle side covers and tool panels for your 125cc model. Enjoy your newly enhanced ride!