Installation Instructions for the 55mm Bright 12 LED Light Bar for 1/10 RC Tracked Vehicles

Tools Required:

1. Screwdriver: A small Phillips or flathead screwdriver may be needed depending on your RC vehicle’s design.
2. Wire Cutters/Stripper: For trimming and preparing wires if necessary.
3. Electrical Tape or Heat Shrink Tubing: To secure connections and provide insulation.
4. Soldering Iron and Solder (optional): For more permanent wire connections.
5. Double-Sided Tape or Mounting Adhesive (optional): If you prefer an adhesive mount for the light bar.

Installation Steps:

1. Prepare Your RC Vehicle:

   • Ensure that the battery is disconnected and the vehicle is turned off before starting the installation.

2. Choose the Mounting Location:

   • Identify a suitable location on your tracked vehicle where the LED light bar can be mounted securely. Common placements are on the front or top of the vehicle.

3. Mount the Light Bar:

   • Use screws to attach the light bar to the desired location on your RC vehicle. If you prefer an adhesive method, apply double-sided tape or mounting adhesive and press firmly to secure.

4. Connect the Wires:

   • If the light bar is not pre-wired, strip the ends of the wires and connect them to your vehicle’s power source, following the polarity (typically red is positive and black is negative).
   • Use electrical tape or heat shrink tubing to insulate and secure the connections.

5. Test the Light Bar:

   • Reconnect the battery and turn on your RC vehicle to ensure the LED light bar is functioning correctly. Check for any loose connections and secure them as needed.

6. Finalize Installation:

   • Once everything is working properly, tidy up any loose wires and ensure that the installation is neat and safe.

Enjoy your enhanced nighttime driving experience with the bright LED light bar on your 1/10 RC vehicle!