Installation Instructions for Replacement Ignition Coil for Lawn Mower Model 118SB Serial Number A1106008823

Tools Required:

1. Screwdriver set (Phillips and flathead)
2. Socket wrench set
3. Pliers
4. Wire cutters/strippers
5. Safety gloves
6. Safety goggles

Installation Steps:

1. Preparation:

   • Make sure your lawn mower is turned off and cooled down before starting the installation.
   • Disconnect the spark plug wire to prevent accidental starts.
   • Wear safety gloves and goggles for protection.

2. Remove the Old Ignition Coil:

   • Locate the old ignition coil, which is typically found near the engine.
   • Use the socket wrench to remove any screws or bolts securing the ignition coil in place.
   • Carefully disconnect any electrical connectors attached to the old ignition coil using pliers.

3. Install the New Ignition Coil:

   • Position the new ignition coil in place, ensuring it aligns with the mounting points.
   • Secure the ignition coil using the screws or bolts you removed earlier.
   • Reconnect the electrical connectors to the new ignition coil, ensuring a snug fit.

4. Reconnect the Spark Plug:

   • Once the new coil is installed, reconnect the spark plug wire to the ignition coil.
   • Make sure it clicks into place securely.

5. Final Checks:

   • Double-check all connections and make sure everything is secure.
   • Re-attach any covers or parts that may have been removed during the installation.

6. Test the Lawn Mower:

   • Start the lawn mower to ensure the new ignition coil is functioning properly.
   • Observe the mowing performance and ensure the lawn mower runs smoothly.

Congratulations! You have successfully installed the Replacement Ignition Coil for your Lawn Mower Model 118SB. Enjoy efficient mowing with improved performance!