Product Installation Instructions for Compatible Motorcycle Oil Filter

Tools Required:

1. Wrench Set - To remove the old oil filter and tighten the new one.
2. Oil Filter Wrench - Optional, but helpful for securely gripping the filter for easy removal.
3. Drain Pan - To catch any oil that may spill during the filter change.
4. Rags or Shop Towels - For cleaning up any spills and wiping surfaces.
5. Funnel - If you're adding new oil after the filter change, a funnel can help prevent spills.
6. New Oil - Make sure to have the correct type and quantity of oil for your specific model.
7. Gloves - To keep your hands clean and protected during the installation process.

Installation Steps:

1. Prepare Your Workspace: Make sure you have a clean, well-lit area to work in and gather all necessary tools and materials.

2. Warm Up the Engine: Start your engine and let it run for a few minutes to warm up the oil. This helps it drain easier.

3. Turn Off the Engine: Once warmed up, turn off the engine and allow it to cool slightly to avoid burns.

4. Place the Drain Pan: Position the drain pan underneath the oil filter to catch any oil that may spill during removal.

5. Remove the Old Oil Filter:

   • Use a wrench or an oil filter wrench to remove the old oil filter.
   • Turn it counterclockwise until it comes off. Be cautious as oil may still be in the filter.

6. Prepare the New Oil Filter:

   • Before installing the new filter, apply a small amount of new oil to the rubber gasket on the top of the new filter. This helps create a better seal.

7. Install the New Oil Filter:

   • Screw the new oil filter onto the engine by hand. Turn it clockwise until it’s snug, but do not overtighten.

8. Add New Oil:

   • Use the funnel to add the appropriate amount of new oil into the engine through the oil fill cap.

9. Check Your Work:

   • Ensure that the oil filter is secure and that there are no leaks.
   • Start the engine and let it run for a minute while checking for leaks around the filter.

10. Clean Up:

    • Dispose of the old oil filter and any spilled oil properly.
    • Wipe down any tools used and clean up your workspace.

Congratulations! You have successfully installed a new compatible oil motorcycle filter. Enjoy improved engine performance and longevity.