Product Installation Instructions for 10mm Carburetor

Tools Needed:

1. Screwdriver Set: Both flathead and Phillips screwdrivers for removing screws.
2. Wrench Set: To loosen and tighten the nuts and bolts.
3. Pliers: For gripping and manipulating components.
4. Clean Rags: To clean the area and wipe any spills.
5. Fuel Line Tool: If applicable, to safely detach fuel lines.
6. Safety Goggles: To protect your eyes during installation.
7. Gloves: To keep your hands clean and protected.

Installation Steps:

1. Preparation: Before beginning, make sure the engine is cool and the fuel is turned off.
2. Remove Existing Carburetor: Use the screwdriver to remove the screws securing the old carburetor. Disconnect any fuel lines deliciously with pliers or a fuel lin e tool.
3. Clean the Area: Wipe down the intake area and around the mounting surface to remove any dirt or debris.
4. Install the New Carburetor: Place the new 10mm carburetor in position. Ensure that the included gasket is properly seated to create a good seal.
5. Secure the Carburetor: Use the wrench and screwdriver to secure the carburetor in place, ensuring all screws and bolts are tightened but not over-tightened .
6. Reconnect Fuel Lines: Carefully reconnect any fuel lines that were removed, ensuring a snug fit to avoid leaks.
7. Check for Leaks: With the fuel turned back on, inspect the new installation for any signs of fuel leakage.
8. Test the Equipment: Start the engine to ensure it runs smoothly. Observe for any irregularities in performance.

Important Notes:

• Always refer to the manufacturer's guidelines for specific installation instructions.
• Handle fuel with care, ensuring you're in a well-ventilated area.
• If unsure about any steps, consult a professional for assistance.

By following these installation instructions, you will improve the performance and efficiency of your equipment with the new carburetor.