Product Installation Instructions for Steering Cup Bearing Set of 4 for 1/14 RC Car Models

Thank you for purchasing the Steering Cup Bearing Set for your 1/14 scale racing RC car models. Please follow the instructions below for a safe and efficient installation.

Tools Needed:

1. Phillips screwdriver
2. Flathead screwdriver
3. Hex wrench set (if applicable)
4. Pliers
5. Clean cloth (for wiping any dust or debris)

Installation Steps:

1. Preparation:

   • Ensure you have a clean and well-lit workspace.
   • Gather all necessary tools listed above before starting the installation.

2. Disassemble the RC Car:

   • Begin by removing the body of the car carefully using the Phillips screwdriver.
   • If necessary, remove any screws or components that may obstruct access to the steering mechanism.

3. Remove Old Bearings:

   • Identify the current steering cup bearings.
   • Use the appropriate screwdriver to remove any screws or bolts holding the old bearings in place.
   • Gently pry the old bearings out using the flathead screwdriver if they are stuck.

4. Install New Bearings:

   • Take the new steering cup bearings from the set and ensure they are free from dust or debris.
     -Align the new bearings into their designated slots.
   • Secure them by replacing any screws or bolts that were removed earlier.

5. Reassemble the Car:

   • Once the new bearings are securely in place, reattach any components that you removed during disassembly.
   • Carefully place the body of the car back on and secure it using the Phillips screwdriver.

6. Final Check:

   • Before testing the car, double-check that all screws and parts are tightly secured.
   • Wipe down any excess oil or grease with a clean cloth.

7. Test the Car:

   • Turn on your RC car and check the steering for smoothness and responsiveness.
   • Make any necessary adjustments if needed.

Congratulations! You have successfully installed the Steering Cup Bearing Set. Enjoy improved performance and handling from your enhanced RC racing car.