Product Installation Instructions for Ship Model Propeller (80mm, 90mm, 100mm)

Tools Required:

1. Screwdriver (Phillips head)
2. Pliers
3. Wrench (for securing the propeller onto the shaft)
4. Measuring tape (optional, for ensuring correct fit)
5. Lubricant (optional, for maintenance purposes)

Installation Steps:

1. Preparation:

   • Ensure you have the correct size propeller (80mm, 90mm, or 100mm) that suits your model.
   • Gather all required tools and ensure your workspace is clean and free of debris.

2. Remove Existing Propeller:

   • Use a screwdriver to remove any screws securing the current propeller.
   • Carefully use pliers to grip the propeller and twist gently to loosen it from the shaft. If it’s stuck, apply some lubricant and let it sit for a few minutes.

3. Clean the Shaft:

   • Once the old propeller is removed, clean the shaft with a cloth to remove any debris or old grease. This will ensure a smooth fit for the new propeller.

4. Install New Propeller:

   • Align the new nylon propeller with the 5mm shaft. Ensure that the propeller's pitch matches the desired direction of thrust.
   • Slide the propeller onto the shaft and push it into place firmly.

5. Secure the Propeller:

   • Use a wrench to tighten the nut or screw that secures the propeller in place. Make sure not to overtighten as this may damage the nylon material.

6. Final Check:

   • Once installed, give the propeller a few spins to ensure it rotates smoothly. Check for any wobble or misalignment.
   • Ensure that all screws and nuts are secured properly.

7. Maintenance Tip:

   • Regularly inspect the propeller for any signs of wear and tear, and clean it after each use in order to maintain its efficiency performance.

Note:
Always refer to the product manual of your specific boat model for detailed installation practices. Enjoy your enhanced boating experience with efficient propulsion!