Product Installation Instructions for Extra Large Rubber Dampers

Compatible Models:
This rubber damper is suitable for various models, including Inspire 2, Zenmuse X5S/X7, M200, and M300 RTK, ensuring a perfect fit.

Installation Tools Required:

1. Screwdriver Set:

   • A set of flat-head and Phillips screwdrivers for removing and installing screws.

2. Pliers:

   • Utility pliers to help grip and pull out any existing dampers if needed.

3. Tweezers:

   • For precise handling of small components when necessary.

4. Soft Cloth:

   • To clean the mounting area before installation, ensuring no dust or debris interferes with the new dampers.

Installation Steps:

1. Preparation:

   • Ensure your drone and camera equipment are powered off and safely placed on a flat surface.

2. Remove Old Dampers:

   • Use the screwdriver and pliers to carefully remove any existing rubber dampers from your device.
   • If necessary, gently pull them out using tweezers for better grip.

3. Clean the Area:

   • Wipe the mounting area with a soft cloth to remove any dust or debris.

4. Install New Dampers:

   • Take the new rubber dampers from the package and align them with the mounting points.
   • Press them firmly into place until they are secure.

5. Verification:

   • Check that the dampers are seated properly and that there are no gaps.

6. Final Check:

   • Once everything is installed, verify that all components are secure and that the drone is ready for flight.

Note:

• Always refer to the manufacturer’s manual for specific instructions related to your drone model.

Thank you for choosing our Extra Large Rubber Dampers! Enjoy enhanced stability and quality in your aerial photography.