Installation Instructions for 4 Pieces Stainless Steel R Type Car Shell Body Clip

Introduction

Thank you for choosing the 4 Pieces Stainless Steel R Type Car Shell Body Clip. This guide will help you with the installation process to ensure your RC crawler operates smoothly and reliably.

Tools Required

• No additional tools required (easy installation with the tab design).
• Optional: Small pliers (for extra grip, if desired).

Installation Steps

1. Preparation:
   Ensure that you have all components ready, including the car body clips and your RC crawler model.

2. Align the Car Body:
   Position the car body onto the chassis of your RC crawler model. Make sure it fits snugly and is aligned properly.

3. Insert the Clips:
   Take one of the stainless steel R type car shell body clips.

   • Locate the designated mounting points on the chassis.
   • Insert the clip through the holes on the car shell and into the chassis mounting points.

4. Secure the Clips:

   • Gently press down on the clip to ensure it is fully engaged.
   • Make sure that the tabs lock securely to prevent the body from loosening during operation.

5. Repeat for Other Clips:
   Repeat steps 3 and 4 for the remaining clips until all are installed and the car body is securely attached.

6. Final Check:
   Ensure all clips are properly secured and that the car shell is firmly attached to the chassis.

###Conclusion
Your RC crawler is now ready for action with the car shell properly installed using the durable stainless steel R type clips. These clips not only provide secure attachment but also allow for easy removal when needed. Enjoy your RC crawling experience!

Maintenance Tips

• Periodically check the clips for wear and replace them as necessary to ensure optimal performance.
• Clean any dirt or debris from the clips after use to maintain their functionality.