Installation Instructions for Lawn Mower Parts and Accessories Spring Kit

Compatible Models: 691859 and 692211

Tools Required:

• Screwdriver (flathead and Phillips head)
• Wrench or socket set
  -Pliers
  -Clean cloth for wiping areas
• Safety goggles
• Work gloves

Installation Steps:

1. Preparation:

   • Ensure the lawn mower is powered off and disconnected from any power source.
   • Place the mower on a stable surface.
   • Wear safety goggles and gloves to protect yourself during the installation.

2. Remove the Existing Parts:

   • Use the appropriate screwdriver to remove any screws or fasteners holding the old spring and gasket in place.
   • Carefully detach the old spring kit and gasket from the mower.

3. Clean the Area:

   • Wipe the area where the spring and gasket were located with a clean cloth to remove any debris or residues. This will help in the proper installation of the new parts.

4. Install the New Spring Kit:

   • Take the new spring and align it as per the old configuration. Ensure it fits snugly into place.
   • Use pliers to secure the spring if necessary and make sure it is seated properly.

5. Install the Gasket:

   • Place the new gasket in its designated position. Press it gently to ensure it adheres correctly without gaps.

6. Replace the Red Non-porous Primer Bulb:

   • If replacing the primer bulb, detach the old one and fit the new red non-porous primer bulb in its place.
   • Ensure it clicks into position securely.

7. Reassemble the Mower:

   • Reattach any screws or fasteners you removed earlier. Use the screwdriver to tighten them securely.
   • Double-check all connections to ensure nothing is loose.

8. Final Checks:

   • Before using the mower, ensure all parts are in their correct position and securely fastened.
   • Reconnect any power sources and perform a quick visual inspection.

Congratulations! Your new Lawn Mower Parts and Accessories Spring Kit is now installed and ready for use. Enjoy enhanced performance and efficiency in your lawn care tasks!