Product Installation Instructions for Spark Plug Compatible with WM80, BS600, BH23

Tools Needed:

1. Ratchet and Socket Set (as per spark plug size)
2. Spark Plug Socket
3. Torque Wrench (optional, for accurate tightening)
4. Extension Bar (if necessary for reach)
5. Gap Tool (to check spark plug gap)
6. Anti-seize Compound (optional, for aid removal)
7. Gloves (for cleanliness)
8. Safety Goggles (for eye protection)

Installation Steps:

1. Preparation:

   • Ensure the engine is cool before starting the installation.
   • Disconnect the negative terminal of the battery to avoid any electrical issues.

2. Remove Old Spark Plug:

   • Locate the spark plug on your engine.
   • Use the ratchet and socket along with the spark plug socket to loosen and remove the old spark plug.
   • If necessary, use an extension bar to reach plugs that are deep within the compartment.

3. Check Spark Plug Gap:

   • Use a gap tool to measure the gap of the new spark plug. Adjust as necessary to meet your engine's specifications.

4. Install the New Spark Plug:

   • If using anti-seize compound, apply a small amount to the threads of the new spark plug to aid in future removals.
   • Carefully thread the new spark plug into the socket by hand initially, ensuring not to cross-thread.
   • Once hand-tight, use the torque wrench to tighten the spark plug to the manufacturer’s recommended torque specification.

5. Reconnect Components:

   • Reattach the ignition cable or coil to the new spark plug.
   • Make sure everything is securely connected and does not interfere with any moving parts.

6. Final Touch:

   • Reconnect the negative terminal of the battery.
   • Start the engine to check for proper operation and ensure there are no leaks or misfires.

7. Clean Up:

   • Dispose of the old spark plug and clean any tools used during the installation.

Congratulations, you have successfully installed your new spark plug! Enjoy the improved performance of your engine.