Installation Instructions for Bumper Spikes Compatible with 137 Chainsaw

Preparation:

Before starting the installation process, ensure you have the following tools ready:

1. Screwdriver: A standard flat-head or Phillips screwdriver depending on the screws used in your chainsaw.

2. Wrench: An adjustable wrench or socket set may be required to remove any bolts.

3. Safety Gear: Always wear safety glasses and gloves to protect yourself during the installation.

4. Clean Cloth: To wipe any debris or residue from the area where the bumper spikes will be installed.

Installation Steps:

1. Turn Off the Chainsaw: Ensure the chainsaw is turned off and disconnected from any power source to prevent accidental start-up.

2. Remove the Existing Bumper Spikes: Use the screwdriver to remove the screws/bolts holding the old bumper spikes in place. Keep these screws, as they may be needed for the new spikes.

3. Clean the Area: Use the clean cloth to wipe the area where the bumper spikes will be attached, removing any dirt or debris.

4. Position the New Bumper Spikes: Align the new bumper spikes with the mounting holes on the chainsaw.

5. Attach the Bumper Spikes: Use the screws/bolts you removed earlier to secure the new bumper spikes in place. Ensure they are tightened securely but avoid over-tightening, which could damage the spikes.

6. Check for Stability: Once installed, check the bumper spikes for stability by gently pulling on them. Ensure there is no movement.

7. Test the Chainsaw: Before starting work, perform a brief test to ensure the bumper spikes are functioning correctly and providing the intended support.

Conclusion:

With just a few tools and these simple steps, you can easily install the Bumper Spikes for your 137 Chainsaw. Enjoy enhanced safety and efficiency in your gardening and forestry tasks!