Installation Instructions for Compatible Recoil Pull Starter Assembly for FS160, FS180, FS220, FS280

Tools Required:

1. Screwdriver Set: A Phillips and flathead screwdriver will be necessary for removing and securing screws during installation.

2. Wrench Set: Depending on the model, you might require a socket or adjustable wrench to remove bolts.

3. Pliers: A pair of pliers can assist in gripping and maneuvering components during installation.

4. Clean Cloth: To wipe any debris or oil from the area around the recoil starter.

5. Safety Goggles: To protect your eyes from debris during the installation process.

Installation Steps:

1. Preparation: Before starting, ensure the equipment is turned off, and the spark plug is disconnected for safety.

2. Remove the Old Starter Assembly:

   • Use the appropriate screwdriver and wrench to remove the screws or bolts holding the old starter assembly.
   • Carefully detach the old assembly from the engine.

3. Inspect the Area: Clean the mounting area with a clean cloth to remove any dirt or debris that may interfere with the installation.

4. Install the New Recoil Pull Starter Assembly:
   -Align the new starter assembly with the mount on the engine.

   • Secure it in place using the screws or bolts you removed earlier. Ensure it is tight but be careful not to overtighten.

5. Reconnect the Spark Plug: Once the new assembly is securely attached, reconnect the spark plug.

6. Test the Installation: Try pulling the recoil to ensure it moves smoothly and starts the engine properly.

7. Clean Up: Gather all tools and any debris from the installation process.

Note: For further instructions or troubleshooting, refer to the manufacturer's manual specific to your model. Enjoy reliable starting performance with your new recoil pull starter!