Installation Instructions for 6 Volt Ignition Coil

Compatibility:
Compatible with C70, CL70, CT70, SL70, XL70, and Z50A motorcycles and small engines.

Tools Required:

1. Screwdriver Set - For removing and securing screws on the motorcycle or engine.
2. Wrench Set - To disconnect and connect any relevant bolts for installation.
3. Wire Stripper/Cutter - To prepare the ignition wire connections.
4. Multimeter - For testing voltage and ensuring proper connections.
5. Electrical Tape - To secure and insulate wire connections after installation.
6. Safety Goggles - To protect your eyes while working on the engine.

Installation Steps:

1. Preparation:

   • Ensure the motorcycle or engine is turned off and the ignition is disconnected for safety.
   • Gather all tools and the new ignition coil for installation.

2. Remove the Old Ignition Coil:

   • Using the screwdriver, remove the screws securing the old ignition coil.
   • Disconnect the wires from the old ignition coil using the wire stripper/cutter if necessary.

3. Install the New Ignition Coil:

   • Position the new 6 Volt Ignition Coil in place.
   • Connect the two wires to the new ignition coil, ensuring a secure and proper fit.
   • Use electrical tape to secure the connections if needed.

4. Secure the Coil:

   • Use the screwdriver to reattach the screws, ensuring the ignition coil is firmly fixed in place.

5. Test the Installation:

   • Reconnect the battery and turn on the ignition.
   • Use the multimeter to check the voltage and ensure the ignition coil is functioning correctly.
   • Start the engine to test for proper ignition performance.

6. Final Check:

   • Make sure everything is securely fastened and functioning.
   • Dispose of the old ignition coil responsibly.

Conclusion:
With the installation of the new 6 Volt Ignition Coil, your motorcycle or small engine should now provide a stable ignition effect, enhancing overall performance. Enjoy your ride!