Here is a product installation manual for the Thermal Unit Sensor:

Thermal Unit Sensor Installation Manual

Model: Thermal Unit Sensor for 420 680 Big Red DN01 700 K16A21 37750KPH701

Compatibility: Compatible with 420 680 Big Red DN01 700 K16A21 37750KPH701

Tools Required:

1. Phillips screwdriver (#2)
2. Torx screwdriver (T10)
3. Pliers (needle-nose)
4. Wire strippers
5. Multimeter (optional)

Precautions:

1. Before starting the installation, make sure to turn off the power to the device.
2. Wear protective gloves and safety glasses to prevent injury from electrical shock or sharp edges.
3. Avoid touching any electrical components during the installation process.

Step 1: Remove the Old Sensor (If Applicable)

1. Locate the old thermal unit sensor and disconnect the wires from the device.
2. Remove any screws or clips holding the sensor in place.
3. Gently pull the old sensor out of its housing.

Step 2: Prepare the New Sensor

1. Take the new thermal unit sensor and inspect it for any damage or defects.
2. Make sure all screws and clips are securely tightened.

Step 3: Install the New Sensor

1. Place the new sensor into its housing, ensuring it is properly seated and aligned.
2. Secure the sensor with screws or clips, making sure they are tightened firmly.
3. Connect the wires to the device, following the wiring diagram provided.

Step 4: Connect Power and Test

1. Turn on the power to the device.
2. Use a multimeter to test the sensor and ensure it is functioning properly.

Step 5: Final Check

1. Verify that the sensor is reading accurately and consistently.
2. Check for any signs of damage or malfunction.

Troubleshooting:

• If the sensor is not reading accurately, check the wiring connections and ensure they are secure.
• If the sensor is damaged, replace it with a new one.

Warranty Information:

• This product is covered by a limited warranty. For more information, please refer to the warranty document provided with the product.

Disclaimer:

• The manufacturer is not responsible for any damage caused by improper installation or misuse of this product.