Installation Instructions for Rubber Tires and Wheels Set

Tools Required:

• Allen wrench (2mm and 3mm)
• Screwdriver (flathead and Phillips)
• Pliers (optional)
• Tire changing pliers (optional)

Installation Steps:

1. Prepare the vehicle: Before installing the new tires and wheels, make sure the RC car is clean and free of any debris.
2. Remove the old tires and wheels: Use a screwdriver to remove the screws holding the old tires and wheels in place. Gently pull the old tires and wheels off the axle.
3. Inspect the axle: Inspect the axle for any dirt or debris and clean it with a soft brush if necessary.
4. Install the new tires and wheels: Place the new tires and wheels onto the axle, ensuring they are securely seated.
5. Tighten the screws: Use an Allen wrench to tighten the screws that hold the tires and wheels in place. Make sure they are snug but not over-tightened.
6. Adjust the tire pressure: Inflate the tires to the recommended pressure, which can be found on the tire's sidewall or in the user manual.
7. Test the vehicle: Take the RC car for a test drive to ensure the new tires and wheels are functioning properly.

Tips and Precautions:

• Make sure to handle the new tires and wheels with care to avoid damage.
• If you encounter any issues during installation, refer to the user manual or contact a professional for assistance.
• Always follow the recommended tire pressure to ensure optimal performance and safety.
• Regularly check and maintain the tires and wheels to ensure they remain in good condition.

By following these steps and using the required tools, you should be able to successfully install the Rubber Tires and Wheels Set for Front and Rear Compatible with 1/16 Scale RC Car Model M16038 HBX16889.