Product Installation Instructions for Compatible Fuel Gas Tank Cap

Compatible Models: 36, 41, 50, 51, 55, 136, 137, 141, 142, 154, 254, 261, 262

Tools Needed:

1. Flathead screwdriver (if needed for prying)
2. Clean cloth (for wiping any spills)
3. Safety gloves (optional)

Installation Steps:

1. Prepare the Workspace:

   • Ensure you are working in a well-ventilated area.
   • Place your chainsaw on a stable surface.

2. Safety First:

   • Wear safety gloves to protect your hands, especially if there is residual fuel in the tank.

3. Remove the Old Fuel Cap:

   • If the old cap is stuck, use the flathead screwdriver to gently pry it off. Be careful not to damage the surrounding area.

4. Clean the Area:

   • Use a clean cloth to wipe around the fuel tank opening. This will help prevent dirt and debris from entering the tank.

5. Install the New Fuel Gas Tank Cap:
   -Align the new cap with the threads of the fuel tank opening.

   • Turn the cap clockwise to secure it. Make sure it is tight but avoid over-tightening.

6. Check for Leaks:

   • After installation, check to ensure there are no fuel leaks around the cap.

7. Test the Chainsaw:

   • Start the chainsaw and allow it to run for a moment to verify that everything is functioning correctly.

Tips:

• Ensure the new cap is compatible with your specific chainsaw model for the best fit.
• Regularly inspect the fuel cap for wear and replace as necessary to maintain performance and safety.

By following these steps, you’ll successfully install your Compatible Fuel Gas Tank Cap, enhancing the performance and safety of your chainsaw. Enjoy your cutting tasks!