Product Installation Instructions for Fuel Bulb Pump Kit

Tools Required:

1. Screwdriver (Phillips or flathead, depending on your device)
2. Pliers
3. Wrench (if applicable for your device)
   4.Clean cloth or towel
4. Safety gloves (recommended for protection)

Installation Steps:

1. Preparation:

   • Ensure that the device (blower, chainsaw, or carburetor) is turned off and disconnect it from any power source.
   • If applicable, drain any remaining fuel to avoid spills.

2. Remove Old Bulb:

   • Use the screwdriver to remove screws securing the existing fuel bulb (if applicable).
   • Carefully pull off the old bulb or pump from its housing. Use pliers if necessary to grip and twist gently.

3. Clean the Area:

   • Wipe the area around where the bulge bulb was installed with a clean cloth to remove any debris or old fuel residue.

4. Install New Bulb:

   • Take your new fuel bulb from the kit. Align it properly with the housing and attach it securely.
   • If screws were removed, reinsert and tighten them using the screwdriver.

5. Check Connections:

   • Ensure all hoses and connections are secure and there are no leaks.
   • Replace any additional parts included in the kit as needed.

6. Reassemble Device:

   • Once everything is installed and tightened down, reassemble any remaining parts of your blower, chainsaw, or carburetor.

7. Final Check:

   • Before operation, double-check that everything is secure and clean.
   • Refill with appropriate fuel and reconnect to the power source (if applicable).

8. Test Device:

   • Start the device to ensure that the new fuel bulb is functioning correctly and that there are no leaks.

Congratulations! You have successfully installed the Fuel Bulb Pump Kit.

For best results, monitor the performance of your device regularly and replace components as required.