Installation Instructions for RC Car Rubber Tires and Wheel Rims with 12mm Hex Hub

Tools Required:

1. Hex Wrench: A 12mm hex wrench is needed to securely attach the wheel rims to the vehicle’s axle.
2. Screwdriver: A small Phillips or flathead screwdriver may be required to adjust any screws, if applicable.
3. Cutting Tool (optional): If you need to remove old or damaged tires, a cutting tool or scissors may be necessary.
4. Cleaning Cloth: To clean the axle and wheel area before installation, ensuring optimal grip.

Installation Steps:

1. Prepare Your Workspace:

   • Make sure you have a clean and flat surface to work on. Gather all your tools and the new tire and rim set.

2. Remove Old Tires:

   • If replacing old tires, use the hex wrench to loosen and remove the wheel rims from the vehicle’s axle.
   • Carefully detach the old tires from the rims if they are still attached.

3. Clean the Axles:

   • Use the cleaning cloth to wipe down the axles to remove any debris. This ensures proper installation and grip.

4. Install New Tires:

   • Position the new tire onto the wheel rim. Ensure it fits snugly and is aligned properly.
   • If necessary, apply even pressure to ensure the tire is seated correctly.

5. Attach the Wheel Rims:

   • Align the wheel rim’s 12mm hex hub with the axle of the RC car.
   • Use the hex wrench to tighten the wheel rim securely onto the axle. Ensure it is firmly attached to prevent any slippage during use.

6. Check Installation:

   • Once all tires have been installed, give each wheel a spin to ensure they rotate freely and are attached correctly.
   • If there’s any wobbling, recheck and tighten as necessary.

7. Final Touch:

   • Ensure that all tools are put away and the workspace is clean. Your RC car is now ready for practice or racing!

Note:
Always consult your RC car’s user manual for specific instructions related to your model’s wheel installation.