Product Installation Instructions for Rear Trunk Release Switch Button Handle Replacement (Elantra AD Model 81260-F2010)

Tools Needed:

1. Flathead Screwdriver - For prying off panels if necessary.
2. Phillips Screwdriver - To remove screws securing the old switch.
3. Socket Wrench Set (if applicable) - May be needed for certain attachment points.
4. Pliers - For any secure connections that may need adjusting.
5. Cleaning Cloth - To clean any debris around the installation area.

Installation Steps:

1. Preparation:

   • Ensure the vehicle is parked on a flat surface.
   • Disconnect the car battery to prevent any electrical issues during installation.

2. Removing the Old Switch:

   • Locate the rear trunk release switch button on your Elantra AD model.
   • Use the flathead screwdriver to gently pry off any cover or panel surrounding the switch.
   • If the switch is secured with screws, use the Phillips screwdriver to remove them.

3. Disconnecting the Old Switch:

   • Carefully disconnect the wiring harness from the old switch. Take note of how it connects for the new installation.

4. Installing the New Switch:

   • Connect the wiring harness to the new rear trunk release switch button, ensuring a secure fit.
   • Position the new switch in place and fasten it down with screws if applicable.
   • If there is any cover or panel, snap it back into place.

5. Testing the New Switch:

   • Reconnect the car battery.
   • Test the new rear trunk release switch to ensure it functions properly.

6. Final Checks:

   • Ensure all connections are secure, and the surrounding area is clean and free from tools or debris.

By following these instructions, you can easily install your new rear trunk release switch button handle, restore its original functionality and enhance your vehicle's convenience.