Product Installation Instructions for Starter Relay Solenoid Compatible with UTV and ATV Models

Thank you for choosing the Starter Relay Solenoid for your compatible UTV or ATV model. Please follow the instructions below for a successful installation.

Tools Required:

1. Socket Wrench Set
2. Screwdriver Set (Flathead and Phillips)
3. Pliers
4. Wire Cutters/Strippers
5. Safety Gloves
6. Safety Goggles

Installation Steps:

1. Preparation:

   • Ensure that your vehicle is parked on a flat and stable surface.
   • Turn off the ignition and remove the key to prevent accidental starting.
   • Disconnect the negative terminal of the battery using a socket wrench to avoid any electrical shorts.

2. Locate the Old Relay:

   • Refer to your vehicle’s manual to find the location of the starter relay solenoid.
   • This is typically located near the battery or engine compartment.

3. Remove the Old Relay:

   • Disconnect the wiring harness from the old relay.
   • Use a socket wrench to remove any bolts securing the relay in place.
   • Carefully remove the old relay from its mounting position.

4. Install the New Relay:

   • Place the new starter relay solenoid in the same position as the old relay.
   • Secure it with the bolts you removed earlier, ensuring it is tightly fastened.
   • Reconnect the wiring harness to the new relay.

5. Reconnect the Battery:

   • Reattach the negative terminal of the battery and tighten it securely with the socket wrench.

6. Test the Relay:

   • Turn the ignition key to the "on" position.
   • Start the vehicle to ensure the new relay is functioning properly.
   • If the engine starts smoothly, the installation is complete.

Safety Tips:

• Always wear safety gloves and goggles while working on your vehicle to protect yourself from dust and debris.
• If you encounter any issues during installation, consult a professional mechanic for assistance.

Thank you for choosing our Starter Relay Solenoid! Enjoy reliable performance and smooth starting in your UTV or ATV.