Product Installation Instructions for 35x47x10.5 Front Fork Suspension Damper Oil Seal Dust Cover

Tools Required:

1. Adjustable Wrench or Socket Set
2. Screwdriver Set (Phillips and Flathead)
3. Soft Cloth or Rag
4. Lubricant (optional, for easier installation)
5. Pliers (if necessary)
6. Torque Wrench (for precise tightening)

Installation Steps:

1. Preparation:

   • Ensure your motorcycle is parked on a level surface and secure it with a stand.
   • Clean the area around the front fork tubes using a soft cloth to remove any dirt and debris.

2. Remove Old Seals:

   • Using a screwdriver, gently pry off the old dust cover from the fork tube. Take care to avoid damaging the fork tube in the process.
   • Inspect the fork tube for any scratches or damage.

3. Lubricate (Optional):

   • Apply a small amount of lubricant around the new dust cover to facilitate easier installation.

4. Install New Dust Cover:

   • Carefully place the new 35x47x10.5 dust cover onto the top of the fork tube.
   • Press down firmly to ensure the cover seats properly in its designated groove.

5. Check Installation:

   • Once installed, visually inspect the dust cover to ensure it is evenly seated. There should be no gaps between the dust cover and the fork tube.

6. Reassemble:

   • If you removed any additional components, reassemble them according to the manufacturer’s specifications.

7. Final Check:

   • Check for any loose fittings and tighten them with the torque wrench as per manufacturer recommendations.

Note: Ensure all tools are in good working condition before use. If you are unfamiliar with motorcycle maintenance, consider consulting a professional mechanic for assistance.

With these steps, you will have successfully installed the new dust cover, enhancing the performance and lifespan of your motorcycle’s suspension system.