Product Installation Instructions for Front Windshield Wiper Washer Jet Nozzle Set (2011-2019 Mid-Size SUV)

Required Tools:

1. Flathead screwdriver
2. Phillips screwdriver (if necessary)
3. Clean cloth or towel (for any spills)

Installation Steps:

1. Preparation:

   • Ensure your vehicle is parked on a level surface and the engine is turned off.
   • Gather all the required tools listed above.

2. Remove Old Nozzles:

   • Locate the existing windshield washer nozzles on your vehicle's hood.
   • If there are any clip or screws securing the old nozzles, use the appropriate screwdriver to remove them carefully.
   • Gently pull the old nozzles out from their housing.

3. Clean the Area:

   • Use a clean cloth or towel to wipe the area where the nozzles were installed. This will help ensure a secure fit for the new nozzles.

4. Install New Nozzles:

   • Take the new washer jet nozzles from the kit.
   • Align them with the mounting holes on the hood and push them firmly into place.
   • If your vehicle requires screws or clips for securing the nozzles, use the screwdriver to fasten them accordingly.

5. Connect the Hose:

   • Ensure the water supply hose is properly attached to the new nozzles to allow for water flow.
   • If needed, replace any damaged hoses for optimal function.

6. Test the Nozzles:

   • Start your vehicle and activate the windshield washer to check the functionality of the new nozzles.
   • Ensure that the spray pattern is even and clear.

7. Final Check:

   • Step back and visually inspect the installation to confirm that everything is securely in place and looks good.

Note: Installation is designed to be simple and tool-free for most applications. However, if you encounter any difficulties, consult a professional mechanic or refer to your vehicle’s service manual.

Enjoy your enhanced windshield visibility and driving safety with your new windshield washer nozzle set!