Installation Instructions for 2x Carburetor Rebuild Kit for Wave XL700 XL760

Tools Required:

1. Screwdriver set (flat-head and Phillips)
2. Socket wrench set
3. Pliers
   4.Carburetor cleaner
   5.Clean cloth or paper towels
4. Small container for holding screws and parts
5. Safety goggles
6. Latex or nitrile gloves (optional)
7. Torque wrench (if applicable)

Installation Steps:

1. Preparation:

   • Ensure the engine is turned off and cool before starting the installation.
   • Disconnect the battery to prevent any electrical issues.

2. Remove the Carburetor:

   • Locate the carburetor on your Wave XL700 or XL760.
   • Use a screwdriver and/or socket wrench to detach the carburetor from the engine.
   • Carefully remove any attached cables and fuel lines.

3. Disassemble the Carburetor:

   • Place the carburetor on a clean, flat surface.
   • Using the appropriate screwdriver, remove the screws that hold the carburetor housing together.
   • Take note of how parts are assembled, or refer to the included installation instructions for guidance.

4. Clean the Components:

   • Use carburetor cleaner to thoroughly clean all components. Remove any dirt, debris, and old fuel residue.
   • Wipe down the parts with a clean cloth or paper towels.

5. Install the Rebuild Kit:

   • Refer to the rebuild kit instructions for specific information on the components included.
   • Replace the old gaskets, O-rings, and any other necessary parts with the new ones from the rebuild kit.
   • Ensure each part is properly aligned and seated.

6. Reassemble the Carburetor:

   • Carefully reassemble the carburetor as per your notes or the provided guidelines.
   • Tighten screws securely but do not over-tighten as this may damage the components.

7. Reinstall the Carburetor:

   • Position the rebuilt carburetor back onto the engine.
   • Reattach any cables and fuel lines carefully to avoid leaks.
   • Secure the carburetor with screws or bolts as required.

8. Final Checks:

   • Reconnect the battery.
   • Inspect for any visible leaks or loose components.
   • If applicable, use a torque wrench to ensure bolts are tightened to manufacturer specifications.

9. Testing:

   • Start the engine and let it warm up to check for proper operation.
   • Adjust the idle speed and mixture if necessary to optimize performance.

Conclusion:
Congratulations! You have successfully installed your 2x Carburetor Rebuild Kit for your Wave XL700 or XL760. Regular maintenance can enhance your engine's performance and longevity. Enjoy the improved efficiency and responsiveness!