Product Installation Instructions for Replacement Lamp Compatible with Projectors VPL-CS1, VPL-CS2, VPL-CX1, LMP-C120

Tools Required:

1. Screwdriver: A small Phillips screwdriver to remove any screws from the projector's lamp compartment.
2. Soft Cloth: To clean the area and avoid dust accumulation.
3. Anti-static Wrist Strap (optional): To prevent static discharge while handling sensitive electronic components.

Installation Steps:

1. Turn Off the Projector: Ensure the projector is completely powered off and unplugged from the electrical outlet. Allow it to cool down for at least 30 minutes to avoid burns.

2. Prepare Your Workspace: Clear a clean and well-lit area to work. Lay down a soft cloth to protect the projector's surface.

3. Locate the Lamp Compartment: Find the lamp compartment cover on your projector. It is usually located at the top or bottom of the unit.

4. Remove the Lamp Cover: Use your screwdriver to remove any screws securing the lamp cover. Carefully take off the cover and set it aside.

5. Remove the Old Lamp:

   • Unclip or unscrew any fasteners holding the old lamp in place.
   • Gently pull the old lamp out of the projector.
   • Avoid touching the glass part of the lamp with your fingers to prevent damage.

6. Prepare the New Lamp:

   • Take the new replacement lamp out of its packaging.
   • Handle it by the plastic casing to prevent contamination of the lamp surface.

7. Install the New Lamp:

   • Slide the new lamp into the projector, aligning it properly with the connectors.
   • Secure it in place by reinserting any clips or screws that were removed.

8. Replace the Lamp Cover:

   • Put the lamp cover back on, ensuring it fits correctly.
   • Replace and tighten any screws to secure the cover.

9. Reconnect the Projector: Plug the projector back into the electrical outlet.

10. Power On Your Projector: Turn on the projector and check to confirm that the new lamp is functioning properly.

11. Dispose of the Old Lamp: Follow local regulations for the disposal of the old lamp, as it may contain materials that require special handling.

By following these steps, you will successfully install your new replacement lamp and enjoy a bright, clear projection experience.