Installation Instructions for Recoil Starter Claw

Product Compatibility:
This Recoil Starter Claw is designed for various trimmer brush cutters, including models OC, SA series, and EF3600, 3800, 4300.

Tools Required:

1. Flathead screwdriver
2. Phillips screwdriver
3. Socket wrench set
4. Pliers
5. Clean cloth (for wiping surfaces)
6. Safety goggles
7. Gloves (for hand protection)

Installation Steps:

1. Preparation:

   • Ensure that the trimmer or brush cutter is turned off and disconnected from the power source.
   • Wear safety goggles and gloves to protect your eyes and hands.

2. Remove the Old Starter:

   • Use the appropriate screwdriver to remove any screws securing the old recoil starter.
   • Carefully detach the old starter from the engine, making note of the configuration.

3. Clean the Area:

   • Wipe the mounting area with a clean cloth to remove any debris or dirt that may interfere with the new installation.

4. Install the New Recoil Starter Claw:
   -Align the new recoil starter claw with the mounting holes on the engine.

   • Secure it in place using the screws removed earlier. Ensure it is tightly fastened but avoid overtightening.

5. Check Alignment:

   • Make sure that the recoil spring and cord are properly aligned and that the starter engages smoothly when pulled.

6. Test the Installation:

   • Reconnect the power source (if applicable) and perform a test pull to ensure that the recoil starter functions correctly and starts the engine reliably.

7. Final Inspection:

   • Double-check all screws and fittings to ensure they are secure.
   • Make sure the area is clear of tools and debris before using the trimmer or brush cutter.

Congratulations!
You have successfully installed your new Recoil Starter Claw. Enjoy enhanced performance and reliability for your trimming and cutting tasks! If you encounter any issues, please refer to the product manual or contact customer support for assistance.