Product Installation Instructions for Metal Upgrade Gearbox for 370 Motor

Tools Required:

1. Phillips screwdriver
2. Hex key set (if necessary for your model)
3. Small pliers
4. Tweezers (optional, for handling small parts)
5. Work mat or surface to prevent parts from rolling away
6. Electrical tape (optional, for securing wires if needed)
7. Safety goggles (recommended)

Installation Steps:

1. Preparation:

   • Ensure you have all the necessary tools ready.
   • Work in a clean, well-lit area to avoid losing small parts.

2. Remove the Existing Gearbox:

   • Turn off your RC vehicle and disconnect the battery.
   • Use the Phillips screwdriver to remove screws securing the current gearbox to the chassis.
   • Carefully detach the old gearbox from the motor and chassis. Use pliers if necessary to gently pry it off.

3. Install the Metal Upgrade Gearbox:

   • Align the new metal gearbox with the motor and the chassis.
   • Ensure that the gearbox fits snugly into place without forcing it.
   • Secure the gearbox using the screws removed previously. Make sure not to overtighten.

4. Reconnect the Motor:

   • Ensure that the motor's wiring is correctly positioned and secured to avoid interference with the gearbox.
   • If needed, use electrical tape to secure any loose wires to prevent them from getting caught in the moving parts.

5. Testing:

   • Reconnect the battery and turn on the RC vehicle.
   • Test the new gearbox by slowly accelerating the vehicle to ensure everything is functioning smoothly.

6. Final Check:

   • After the test run, inspect the installation for any loose screws or connections.
   • Make sure the gearbox is securely attached and functioning as intended.

7. Enjoy Your Enhanced RC Vehicle:

   • Once everything is secured and tested, take your upgraded RC vehicle for a spin and enjoy the enhanced performance!

Note:
Always refer to the specific model's manual if you encounter any difficulties or if parts differ from those described in this guide. Happy racing!